Table of Contents
Advertisement
auto-traffic-control
alarm-fire-threshold
D
S
EFAULT
ETTING
128 kilo-packets per second
C
M
OMMAND
ODE
Interface Configuration (Ethernet)
C
U
OMMAND
SAGE
Once the traffic rate falls beneath the lower threshold, a trap message
◆
may be sent if configured by the
broadcast-alarm-clear
multicast-alarm-clear
If rate limiting has been configured as a control response, it will be
◆
discontinued after the traffic rate has fallen beneath the lower
threshold, and the release timer has expired. Note that if a port has
been shut down by a control response, it will not be re-enabled by
automatic traffic control. It can only be manually re-enabled using the
auto-traffic-control control-release
E
XAMPLE
This example sets the clear threshold for automatic storm control for
broadcast traffic on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast alarm-clear-threshold 155
Console(config-if)#
This command sets the upper threshold for ingress traffic beyond which a
storm control response is triggered after the apply timer expires. Use the
no form to restore the default setting.
S
YNTAX
auto-traffic-control {broadcast | multicast}
alarm-fire-threshold threshold
no auto-traffic-control {broadcast | multicast}
alarm-fire-threshold
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
threshold - The upper threshold for ingress traffic beyond which a
storm control response is triggered after the apply timer expires.
(Range: 1-255 kilo-packets per second)
D
S
EFAULT
ETTING
128 kilo-packets per second
C
M
OMMAND
ODE
Interface Configuration (Ethernet)
– 1013 –
| Congestion Control Commands
C
30
HAPTER
Automatic Traffic Control Commands
snmp-server enable port-traps atc
command or
snmp-server enable port-traps atc
command.
command.
Advertisement
Chapters
Table of Contents
