Network-Access Port-Mac-Filter; Mac-Authentication Intrusion-Action - Edge-Core ECS4810-12M Layer 2 Management Manual

| General Security Measures
C 25
HAPTER
Network Access (MAC Address Authentication)
network-access
port-mac-filter
mac-authentication
intrusion-action
Use this command to enable the specified MAC address filter. Use the no
form of this command to disable the specified MAC address filter.
S
YNTAX
network-access port-mac-filter filter-id
no network-access port-mac-filter
filter-id - Specifies a MAC address filter table. (Range: 1-64)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Interface Configuration
C M
OMMAND ODE
Entries in the MAC address filter table can be configured with the
◆
network-access mac-filter
Only one filter table can be assigned to a port.
◆
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#network-access port-mac-filter 1
Console(config-if)#
Use this command to configure the port response to a host MAC
authentication failure. Use the no form of this command to restore the
default.
S
YNTAX
mac-authentication intrusion-action {block traffic | pass traffic}
no mac-authentication intrusion-action
D S
EFAULT ETTING
Block Traffic
C M
OMMAND ODE
Interface Configuration
E
XAMPLE
Console(config-if)#mac-authentication intrusion-action block-traffic
Console(config-if)#
– 878 –
command.