Logging Sendmail Destination-Email; Logging Sendmail Source-Email - Edge-Core ECS4810-12M Layer 2 Management Manual

This command specifies the email recipients of alert messages. Use the no
logging sendmail
form to remove a recipient.
destination-email
S
YNTAX
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
You can specify up to five recipients for alert messages. However, you must
enter a separate command to specify each recipient.
E
XAMPLE
This command sets the email address used for the "From" field in alert
logging sendmail
messages. Use the no form to restore the default value.
source-email
S
YNTAX
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
E
XAMPLE
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
S
ETTING
M
ODE
U
SAGE
Console(config)#logging sendmail destination-email ted@this-company.com
Console(config)#
logging sendmail source-email email-address
no logging sendmail source-email
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
S
ETTING
M
ODE
U
SAGE
Console(config)#logging sendmail source-email bill@this-company.com
Console(config)#
– 735 –
| System Management Commands
C 20
HAPTER
SMTP Alerts