Hardware Configuration - Teledyne BOSON+ CZ 14-75 User Manual

4. HARDWARE CONFIGURATION

The Boson+ CZ 14-75 includes the 14-75 mm continuous zoom (CZ) lens integrated with the
Boson+ camera module. The CZ lens and infrared (IR) camera module are assembled at the
Teledyne FLIR factory to provide an infinity-focused IR image to the camera. Users must select
an accessory board and connect the power/communication cable for the camera system. It is
configured with a Camera Link® accessory board and power/communication cables in Figure 2
and Figure 4. Datasheet (Doc.# 102-2013-40) for the camera from Teledyne FLIR provides the
list of accessories. The lens controller and the camera need separate power and communication
cables. The input power of the lens controller is 12 VDC, and the input power for the camera
module is 3.3 VDC.
Document M-008 Revision A. Approved for public release: Teledyne FLIR approved [FLIRGTC-SBA-018].
© 2023 Teledyne FLIR
Figure 2. Simplified block diagram of the hardware
BOSON+ CZ 14-75 USER MANUAL
Page 5