Configuring Ethernet Communication Using Dynamic Host Configuration Protocol (Dhcp); Figure 6-5: Comm - Lan / Internet Automatic Configuration - Teledyne t100 Operation Manual

Teledyne API - T100 UV Fluorescence SO
6.5.2. CONFIGURING ETHERNET COMMUNICATION USING DYNAMIC
HOST CONFIGURATION PROTOCOL (DHCP)
SETUP X.X
From this point on,
EXIT returns to
COMMUNICATIONS
MENU
SAMPLE
SETUP X.X
SETUP X.X
SETUP X.X
SETUP X.X
SETUP X.X
SETUP X.X
SETUP X.X
06807F DCN7335
Analyzer
2
1. Consult with your network administrator to affirm that your network server is running
DHCP.
2. Access the Communications Menu as shown in Figure 5-13.
3. Follow the setup sequence as shown in Figure 6-5.
COMMUNICATIONS MENU
ID INET COM1 COM2
ENTER SETUP PASS : 818
8 1 8
DHCP: ON
SET> EDIT
INST IP: 0.0.0.0
<SET SET>
GATEWAY IP: 0.0.0.0
<SET SET>
SUBNET MASK: 0.0.0.0
<SET SET>
TCP PORT: 3000
<SET SET> EDIT
TCP PORT2: 502
<SET SET> EDIT
HOSTNAME:
<SET EDIT
Figure 6-5: COMM – LAN / Internet Automatic Configuration
Communications Setup and Operation
EXIT
ENTR EXIT
DHCP: ON is
default setting.
If it has been
set to OFF,
press EDIT
EXIT
and set to ON.
EXIT
EDIT button
disabled
EXIT
EXIT
Do not alter unless
directed to by Teledyne
Instruments Customer
Service personnel
EXIT
EXIT
EXIT
SETUP X.X DHCP: OFF
OFF ENTR EXIT
SETUP X.X DHCP: ON
ON ENTR EXIT
135