Pppoe Intermediate-Agent Port-Enable - Edge-Core ECS4110-28T Management Manual

| Authentication Commands
C 24
HAPTER
PPPoE Intermediate Agent
pppoe
intermediate-agent
port-enable
D S
EFAULT ETTING
◆ Access Node Identifier: IP address of the management interface.
Generic Error Message: PPPoE Discover packet too large to process. Try
◆
reducing the number of tags added.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The switch uses the access-node-identifier to generate the circuit-id for
◆
PPPoE discovery stage packets sent to the BRAS, but does not modify
the source or destination MAC address of these PPPoE discovery
packets.
These messages are forwarded to all trusted ports designated by the
◆
pppoe intermediate-agent trust
E
XAMPLE
Console(config)#pppoe intermediate-agent format-type access-node-identifier
billibong
Console(config)#
This command enables the PPPoE IA on an interface. Use the no form to
disable this feature.
S
YNTAX
[no] pppoe intermediate-agent port-enable
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
PPPoE IA must also be enabled globally on the switch for this command to
take effect.
E
XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#pppoe intermediate-agent port-enable
Console(config-if)#
– 882 –
command.