Table 140: Erps Request/State Priority - Edge-Core ECS4110-28T Management Manual

28/52-port gigabit ethernet layer 2+ switch
Hide thumbs Also See for ECS4110-28T:
Table of Contents

Advertisement

| ERPS Commands
C
36
HAPTER
other ring nodes of the FS command and that the traffic channel is
blocked on one ring port.
A ring node accepting an R-APS (FS) message, without any local
c.
higher priority requests unblocks any blocked ring port. This action
subsequently unblocks the traffic channel over the RPL.
The ring node accepting an R-APS (FS) message, without any local
d.
higher priority requests stops transmission of R-APS messages.
The ring node receiving an R-APS (FS) message flushes its FDB.
e.
Protection switching on a forced switch request is completed when the
above actions are performed by each ring node. At this point, traffic
flows around the ring are resumed. From this point on the following
rules apply regarding processing of further forced switch commands:
While an existing forced switch request is present in a ring, any new
forced switch request is accepted, except on a ring node having a prior
local forced switch request. The ring nodes where further forced switch
commands are issued block the traffic channel and R-APS channel on
the ring port at which the forced switch was issued. The ring node
where the forced switch command was issued transmits an R-APS
message over both ring ports indicating FS. R-APS (FS) messages are
continuously transmitted by this ring node while the local FS command
is the ring node's highest priority command. As such, two or more
forced switches are allowed in the ring, which may inadvertently cause
the segmentation of an ring. It is the responsibility of the operator to
prevent this effect if it is undesirable.
Ring protection requests, commands and R-APS signals have the
priorities as specified in the following table.

Table 140: ERPS Request/State Priority

Request / State and Status
Clear
FS
R-APS (FS)
local SF
*
local clear SF
R-APS (SF)
R-APS (MS)
MS
WTR Expires
WTR Running
WTB Expires
WTB Running
– 1142 –
Type
Priority
local
highest
local
|
remote
|
local
|
local
|
remote
|
remote
|
local
|
local
|
local
|
local
|
local
|

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecs4110-28pEcs4110-52tEcs4110-52p

Table of Contents