Table 30: Remote Port Auto-Negotiation Advertised Capability - Edge-Core ECS4110-28T Management Manual

28/52-port gigabit ethernet layer 2+ switch
Hide thumbs Also See for ECS4110-28T:
Table of Contents

Advertisement

| Basic Administration Protocols
C
14
HAPTER
Link Layer Discovery Protocol
System Capabilities Enabled – The primary function(s) of the
system which are currently enabled. (See
Capabilities," on page
Management Address List – The management addresses for this
device. Since there are typically a number of different addresses
associated with a Layer 3 device, an individual LLDP PDU may contain
more than one management address TLV.
If no management address is available, the address should be the MAC
address for the CPU or for the port sending this advertisement.
Port Details – 802.1 Extension Information
Remote Port VID – The port's default VLAN identifier (PVID) indicates
the VLAN with which untagged or priority-tagged frames are
associated.
Remote Port-Protocol VLAN List – The port-based protocol VLANs
configured on this interface, whether the given port (associated with
the remote system) supports port-based protocol VLANs, and whether
the port-based protocol VLANs are enabled on the given port associated
with the remote system.
Remote VLAN Name List – VLAN names associated with a port.
Remote Protocol Identity List – Information about particular
protocols that are accessible through a port. This object represents an
arbitrary local integer value used by this agent to identify a particular
protocol identity, and an octet string used to identify the protocols
associated with a port of the remote system.
Port Details – 802.3 Extension Port Information
Remote Port Auto-Neg Supported – Shows whether the given port
(associated with remote system) supports auto-negotiation.
Remote Port Auto-Neg Adv-Capability – The value (bitmap) of the
ifMauAutoNegCapAdvertisedBits object (defined in IETF RFC 3636)
which is associated with a port on the remote system.

Table 30: Remote Port Auto-Negotiation Advertised Capability

Bit
0
1
2
3
4
5
6
7
– 440 –
Table 28, "System
436.)
Capability
other or unknown
10BASE-T half duplex mode
10BASE-T full duplex mode
100BASE-T4
100BASE-TX half duplex mode
100BASE-TX full duplex mode
100BASE-T2 half duplex mode
100BASE-T2 full duplex mode

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecs4110-28pEcs4110-52tEcs4110-52p

Table of Contents