Edge-Core ECS4110-28T Management Manual page 1285

D
EFAULT
No profiles are defined
C
OMMAND
Global Configuration
C
OMMAND
Use this command to statically configure all multicast group addresses
◆
that will join the MVR VLAN. Any multicast data associated an MVR
group is sent from all source ports to all receiver ports that have
registered to receive data from that multicast group.
The IP address range from 224.0.0.0 to 239.255.255.255 is used for
◆
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
IGMP snooping and MVR share a maximum number of 1023 groups.
◆
Any multicast streams received in excess of this limitation will be
flooded to all ports in the associated domain.
E
XAMPLE
The following example maps a range of MVR group addresses to a profile:
Console(config)#mvr profile rd 228.1.23.1 228.1.23.10
Console(config)#
This command configures the interval at which the receiver port sends out
mvr proxy-
general queries. Use the no form to restore the default setting.
query-interval
S
YNTAX
mvr proxy-query-interval interval
no mvr proxy-query-interval
D
EFAULT
125 seconds
C
OMMAND
Global Configuration
C
OMMAND
This command sets the general query interval at which active receiver
ports send out general queries. This interval is only effective when proxy
switching is enabled with the
S
ETTING
M
ODE
U
SAGE
interval - The interval at which the receiver port sends out general
queries. (Range: 2-31744 seconds)
S
ETTING
M
ODE
U
SAGE
mvr proxy-switching
– 1285 –
| Multicast Filtering Commands
C 40
HAPTER
command.
MVR for IPv4