Figure 233: Configuring LLDP Interface Attributes
Use the Administration > LLDP (Configure Interface – Add CA-Type) page
C
ONFIGURING
to specify the physical location of the device attached to an interface.
LLDP I
NTERFACE
C
-A
IVIC
DDRESS
CLI R
◆
C
OMMAND
◆
EFERENCES
"lldp med-location civic-addr" on page 1336
U
SAGE
Use the Civic Address type (CA-Type) to advertise the physical location
of the device attached to an interface, including items such as the city,
street number, building and room information. The address location is
specified as a type and value pair, with the civic address type defined in
RFC 4776. The following table describes some of the CA type numbers
and provides examples.
Table 26: LLDP MED Location CA Types
CA Type Description
1
National subdivisions (state, canton, province)
2
County, parish
3
City, township
4
City division, borough, city district
5
Neighborhood, block
6
Group of streets below the neighborhood level
– 433 –
| Basic Administration Protocols
C
14
HAPTER
Link Layer Discovery Protocol
CA Value Example
California
Orange
Irvine
West Irvine
Riverside
Exchange