Displaying Local Meps - Edge-Core ECS4110-28T Management Manual

| Basic Administration Protocols
C 14
HAPTER
Connectivity Fault Management
D
ISPLAYING
L MEP
OCAL S
Use the Administration > CFM > Show Information (Show Local MEP) page
to show information for the MEPs configured on this device.
CLI R
EFERENCES
"show ethernet cfm maintenance-points local" on page 1363
◆
P
ARAMETERS
These parameters are displayed:
MEP ID – Maintenance end point identifier.
◆
MD Name – Maintenance domain name.
◆
Level – Authorized maintenance level for this domain.
◆
Direction – Direction in which the MEP communicates CFM messages:
◆
Down indicates that the MEP is facing away from the switch, and
■
transmits CFM messages towards, and receives them from, the
direction of the physical medium.
Up indicates that the MEP faces inward toward the switch cross-
■
connect matrix, and transmits CFM messages towards, and receives
them from, the direction of the internal bridge relay mechanism.
Primary VLAN – Service VLAN ID.
◆
Interface – Physical interface of this entry (either a port or trunk).
◆
◆ CC Status – Shows administrative status of CCMs.
MAC Address – MAC address of this MEP entry.
◆
W I
EB NTERFACE
To show information for the MEPs configured on this device:
Click Administration, CFM.
1.
Select Show Information from the Step list.
2.
Select Show Local MEP from the Action list.
3.
Figure 311: Showing Information on Local MEPs
– 546 –