Edge-Core ECS4110-28T Management Manual page 1314

| Multicast Filtering Commands
C 40
HAPTER
MVR for IPv6
clear mvr6 groups
dynamic
group - Defines a multicast service sent to the selected port.
ip-address - Statically configures an interface to receive multicast
traffic from the IPv6 address specified for an MVR multicast group.
This parameter must be a full IPv6 address including the network
prefix and host address bits.
D S
EFAULT ETTING
No receiver port is a member of any configured multicast group.
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
Multicast groups can be statically assigned to a receiver port using this
◆
command. The assigned address must fall within the range set by the
mvr6 associated-profile
All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
◆
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
The MVR VLAN cannot be specified as the receiver VLAN for static
◆
bindings.
E
XAMPLE
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/2
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#mvr6 domain 1 vlan 2 group ff00::1
Console(config-if)#
This command clears multicast group information dynamically learned
through MVR6.
S
YNTAX
clear mvr6 groups dynamic [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
This command only clears entries learned though MVR6. Statically
configured multicast addresses are not cleared.
– 1314 –
command.