Edge-Core ECS4110-28T Management Manual page 1136

| ERPS Commands
C 36
HAPTER
ring-port
Figure 425: Sub-ring without Virtual Channel
RPL Port
E
XAMPLE
Console(config-erps)#raps-without-vc
Console(config-erps)#
This command configures a node's connection to the ring through the east
or west interface. Use the no form to disassociate a node from the ring.
S
YNTAX
ring-port {east | west} interface interface
east - Connects to next ring node to the east.
west - Connects to next ring node to the west.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
D S
EFAULT ETTING
Not associated
C M
OMMAND ODE
ERPS Configuration
C U
OMMAND SAGE
Each node must be connected to two neighbors on the ring. For
◆
convenience, the ports connected are referred to as east and west
ports. Alternatively, the closest neighbor to the east should be the next
node in the ring in a clockwise direction, and the closest neighbor to the
west should be the next node in the ring in a counter-clockwise
direction.
◆ Note that a ring port cannot be configured as a member of a spanning
tree, a dynamic trunk, or a static trunk.
– 1136 –
Interconnection Node
Major Ring
Sub-ring
with Virtual
Channel
Ring Node