Assigning Static Mvr6 Multicast Groups To Interfaces - Edge-Core ECS4110-28T Management Manual

| Multicast Filtering
C 15
HAPTER
Multicast VLAN Registration for IPv6
A S
SSIGNING TATIC
MVR6 M
ULTICAST
G
ROUPS TO
I
NTERFACES
By Host IP – The router/querier will not send out a group-specific
■
query when an MLDv1/v2 Listener Done message is received (the
same as it would without this option having been used). Instead of
immediately deleting that group, it will look up the record, and only
delete the group if there are no other subscribers for it on the
member port. Only when all hosts on that port leave the group will
the member port be deleted.
W I
EB NTERFACE
To configure interface settings for MVR6:
Click Multicast, MVR6.
1.
Select Configure Interface from the Step list.
2.
Select Port or Trunk interface.
3.
Select an MVR6 domain.
4.
Set each port that will participate in the MVR6 protocol as a source port
5.
or receiver port, and optionally enable Immediate Leave on any
receiver port to which only one subscriber is attached.
Click Apply.
6.
Figure 374: Configuring Interface Settings for MVR6
Use the Multicast > MVR6 (Configure Static Group Member) page to
statically bind multicast groups to a port which will receive long-term
multicast streams associated with a stable set of hosts.
CLI R
EFERENCES
◆ "mvr6 vlan group" on page 1313
C U
OMMAND SAGE
Multicast groups can be statically assigned to a receiver port using this
◆
configuration page.
– 630 –