Edge-Core ECS4110-28T Management Manual page 751

This command enables password checking at login. Use the no form to
login
disable password checking and allow connections without a password.
S
YNTAX
login [local]
no login
local - Selects local password checking. Authentication is based on
the user name specified with the
D S
EFAULT ETTING
login local
C M
OMMAND ODE
Line Configuration
C U
OMMAND SAGE
There are three authentication modes provided by the switch itself at
◆
login:
login selects authentication by a single global password as
■
specified by the
this method, the management interface starts in Normal Exec (NE)
mode.
login local selects authentication via the user name and password
■
specified by the
using this method, the management interface starts in Normal Exec
(NE) or Privileged Exec (PE) mode, depending on the user's
privilege level (0 or 15 respectively).
no login selects no authentication. When using this method, the
■
management interface starts in Normal Exec (NE) mode.
This command controls login authentication via the switch itself. To
◆
configure user names and passwords for remote authentication
servers, you must use the RADIUS or TACACS software installed on
those servers.
E
XAMPLE
Console(config-line)#login local
Console(config-line)#
R C
ELATED OMMANDS
username (825)
password (752)
| System Management Commands
C 21
HAPTER
username
password line configuration command. When using
username command (i.e., default setting). When
– 751 –
Line
command.