Table 163: Multicast Filtering Commands - Edge-Core ECS4110-28T Management Manual

40
M
ULTICAST
This switch uses IGMP (Internet Group Management Protocol) to check for
any attached hosts that want to receive a specific multicast service. It
identifies the ports containing hosts requesting a service and sends data
out to those ports only. It then propagates the service request up to any
neighboring multicast switch/router to ensure that it will continue to
receive the multicast service.

Table 163: Multicast Filtering Commands

Command Group Function
IGMP Snooping Configures multicast groups via IGMP snooping or static
assignment, sets the IGMP version, enables proxy reporting,
displays current snooping settings, and displays the multicast
service and group members
Static Multicast Routing Configures static multicast router ports which forward all inbound
multicast traffic to the attached VLANs
IGMP Filtering and Configures IGMP filtering and throttling
Throttling
MLD Snooping Configures Multicast Listener Discovery snooping for IPv6
MLD Filtering and Configures MLD filtering and throttling for IPv6.
Throttling
MVR for IPv4 Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving
security and data isolation for normal traffic
MVR for IPv6 Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving
security and data isolation for normal traffic
– 1225 –
F C
ILTERING OMMANDS