Showing Ipv6 Addresses - Edge-Core ECS4110-28T Management Manual

| IP Configuration
C 16
HAPTER
Setting the Switch's IP Address (IP Version 6)
S IP 6
HOWING V
A
DDRESSES
Link Local – Configures an IPv6 link-local address.
■
The address prefix must be in the range of FE80~FEBF.
■
You can configure only one link-local address per interface.
■
The specified address replaces a link-local address that was
■
automatically generated for the interface.
◆ IPv6 Address – IPv6 address assigned to this interface.
W I
EB NTERFACE
To configure an IPv6 address:
Click IP, IPv6 Configuration.
1.
Select Add IPv6 Address from the Action list.
2.
Specify the VLAN to configure, select the address type, and then enter
3.
an IPv6 address and prefix length.
Click Apply.
4.
Figure 387: Configuring an IPv6 Address
Use the IP > IPv6 Configuration (Show IPv6 Address) page to display the
IPv6 addresses assigned to an interface.
CLI R
EFERENCES
"show ipv6 interface" on page 1442
◆
P
ARAMETERS
These parameters are displayed:
VLAN – ID of a configured VLAN. By default, all ports on the switch are
◆
members of VLAN 1. However, the management station can be
attached to a port belonging to any VLAN, as long as that VLAN has
been assigned an IP address. (Range: 1-4094)
◆ IPv6 Address Type – The address type (Global, EUI-64, Link Local).
IPv6 Address – An IPv6 address assigned to this interface.
◆
– 652 –