Edge-Core ECS4110-28T Management Manual page 1167

switchport
dot1q-tunnel mode
This command configures an interface as a QinQ tunnel port. Use the no
form to disable QinQ on the interface.
S
YNTAX
switchport dot1q-tunnel mode {access | uplink}
no switchport dot1q-tunnel mode
access – Sets the port as an 802.1Q tunnel access port.
uplink – Sets the port as an 802.1Q tunnel uplink port.
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
QinQ tunneling must be enabled on the switch using the
◆
system-tunnel-control
mode interface command can take effect.
◆ When a tunnel uplink port receives a packet from a customer, the
customer tag (regardless of whether there are one or more tag layers)
is retained in the inner tag, and the service provider's tag added to the
outer tag.
When a tunnel uplink port receives a packet from the service provider,
◆
the outer service provider's tag is stripped off, and the packet passed
on to the VLAN indicated by the inner tag. If no inner tag is found, the
packet is passed onto the native VLAN defined for the uplink port.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel mode access
Console(config-if)#
R C
ELATED OMMANDS
show dot1q-tunnel (1171)
show interfaces switchport (1008)
– 1167 –
C
HAPTER
Configuring IEEE 802.1Q Tunneling
command before the switchport dot1q-tunnel
| VLAN Commands
37
dot1q-tunnel