Edge-Core ECS4110-28T Management Manual page 1063

auto-traffic-control
auto-traffic-control
action
This command enables automatic traffic control for broadcast or multicast
storms. Use the no form to disable this feature.
S
YNTAX
[no] auto-traffic-control {broadcast | multicast}
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
C U
OMMAND SAGE
Automatic storm control can be enabled for either broadcast or
◆
multicast traffic. It cannot be enabled for both of these traffic types at
the same time.
◆ Automatic storm control is a software level control function. Traffic
storms can also be controlled at the hardware level using the
switchport packet-rate
types can be applied to a port. Enabling automatic storm control on a
port will disable hardware-level storm control on that port.
E
XAMPLE
This example enables automatic storm control for broadcast traffic on port
1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast
Console(config-if)#
This command sets the control action to limit ingress traffic or shut down
the offending port. Use the no form to restore the default setting.
S
YNTAX
auto-traffic-control {broadcast | multicast} action
{rate-control | shutdown}
no auto-traffic-control {broadcast | multicast} action
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
rate-control - If a control response is triggered, the rate of ingress
traffic is limited based on the threshold configured by the
traffic-control alarm-clear-threshold
– 1063 –
| Congestion Control Commands
C 31
HAPTER
Automatic Traffic Control Commands
command. However, only one of these control
command.
auto-