Edge-Core ECS4110-28T Management Manual page 1291

This command configures an interface as an MVR receiver or source port.
mvr type
Use the no form to restore the default settings.
S
YNTAX
[no] mvr [domain domain-id] type {receiver | source}
domain-id - An independent multicast domain. (Range: 1-5)
receiver - Configures the interface as a subscriber port that can
receive multicast data.
source - Configures the interface as an uplink port that can send
and receive multicast data for the configured multicast groups.
D S
EFAULT ETTING
The port type is not defined.
C M
OMMAND
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND
A port which is not configured as an MVR receiver or source port can
◆
use IGMP snooping to join or leave multicast groups using the standard
rules for multicast filtering.
Receiver ports can belong to different VLANs, but should not normally
◆
be configured as a member of the MVR VLAN. IGMP snooping can also
be used to allow a receiver port to dynamically join or leave multicast
groups not sourced through the MVR VLAN. Also, note that VLAN
membership for MVR receiver ports cannot be set to access mode (see
the switchport mode
One or more interfaces may be configured as MVR source ports. A
◆
source port is able to both receive and send data for multicast groups
which it has joined through the MVR protocol or which have been
assigned through the
Only IGMP version 2 or 3 hosts can issue multicast join or leave
◆
messages. If MVR must be configured for an IGMP version 1 host, the
multicast groups must be statically assigned using the
command.
E
XAMPLE
The following configures one source port and several receiver ports on the
switch.
Console(config)#interface ethernet 1/5
Console(config-if)#mvr domain 1 type source
Console(config-if)#exit
Console(config)#interface ethernet 1/6
Console(config-if)#mvr domain 1 type receiver
Console(config-if)#exit
Console(config)#interface ethernet 1/7
Console(config-if)#mvr domain 1 type receiver
C
ODE
SAGE
command).
mvr vlan group
– 1291 –
| Multicast Filtering Commands
40
HAPTER
command.
MVR for IPv4
mvr vlan group