Edge-Core ECS4110-28T Management Manual page 514

| Basic Administration Protocols
C 14
HAPTER
Ethernet Ring Protection Switching
Click Apply.
5.
Figure 290: Creating an ERPS Ring
To configure the ERPS parameters for a ring:
Click Administration, ERPS.
1.
Select Configure Domain from the Step list.
2.
Select Configure Details from the Action list.
3.
Configure the ERPS parameters for this node. Note that spanning tree
4.
protocol cannot be configured on the ring ports, nor can these ports be
members of a static or dynamic trunk. And the control VLAN must be
unique for each ring. Adjust the protocol timers as required. The RPL
owner must be set on one of the rings. And the administrative status
enabled once all of the other settings have been entered.
Click Apply.
5.
– 514 –