Edge-Core ECS4110-28T Management Manual page 1056

| Congestion Control Commands
C 31
HAPTER
Rate Limit Commands
rate-limit
This command defines the rate limit for a specific interface. Use this
command without specifying a rate to enable rate limiting. Use the no form
to disable rate limiting.
S
YNTAX
rate-limit {input | output} [rate]
no rate-limit {input | output}
input – Input rate for specified interface
output – Output rate for specified interface
rate – Maximum value in kbps. (Range: 64-1000000 kbps)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
Using both rate limiting and storm control on the same interface may lead
to unexpected results. It is therefore not advisable to use both of these
commands on the same interface.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 64
Console(config-if)#
R C
ELATED OMMAND
show interfaces switchport (1008)
– 1056 –