Configuring Igmp Filter Profiles - Edge-Core ECS4110-28T Management Manual

Figure 339: Enabling IGMP Filtering and Throttling
Use the Multicast > IGMP Snooping > Filter (Configure Profile – Add) page
C IGMP
ONFIGURING
to create an IGMP profile and set its access mode. Then use the (Add
F P
ILTER ROFILES
Multicast Group Range) page to configure the multicast groups to filter.
CLI R
◆
C
Specify a range of multicast groups by entering a start and end IP address;
or specify a single multicast group by entering the same IP address for the
start and end of the range.
P
These parameters are displayed:
Add
◆
◆
Add Multicast Group Range
◆
◆
◆
EFERENCES
"IGMP Filtering and Throttling" on page 1250
U
OMMAND SAGE
ARAMETERS
Profile ID – Creates an IGMP profile. (Range: 1-4294967295)
Access Mode – Sets the access mode of the profile; either permit or
deny. (Default: Deny)
When the access mode is set to permit, IGMP join reports are
processed when a multicast group falls within the controlled range.
When the access mode is set to deny, IGMP join reports are only
processed when the multicast group is not in the controlled range.
Profile ID – Selects an IGMP profile to configure.
Start Multicast IP Address – Specifies the starting address of a
range of multicast groups.
End Multicast IP Address – Specifies the ending address of a range
of multicast groups.
– 591 –
| Multicast Filtering
C 15
HAPTER
Filtering and Throttling IGMP Groups