Edge-Core ECS4110-28T Management Manual page 1158

| VLAN Commands
C 37
HAPTER
Configuring VLAN Interfaces
switchport
acceptable-frame-
types
E
XAMPLE
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
R C
ELATED OMMANDS
shutdown (1002)
interface (996)
vlan (1156)
This command configures the acceptable frame types for a port. Use the
no form to restore the default.
S
YNTAX
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
all - The port accepts all frames, tagged or untagged.
tagged - The port only receives tagged frames.
D S
EFAULT ETTING
All frame types
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
When set to receive all frame types, any received frames that are untagged
are assigned to the default VLAN.
E
XAMPLE
The following example shows how to restrict the traffic received on port 1
to tagged frames:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#
R C
ELATED OMMANDS
switchport mode (1161)
– 1158 –