Edge-Core ECS4110-28T Management Manual page 1069

snmp-server
enable port-traps
atc broadcast-
control-release
snmp-server
enable port-traps
atc multicast-alarm-
clear
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered and the
release timer expires. Use the no form to disable this trap.
S
YNTAX
[no] snmp-server enable port-traps atc
broadcast-control-release
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-
release
Console(config-if)#
R C
ELATED OMMANDS
auto-traffic-control alarm-clear-threshold (1064)
auto-traffic-control action (1063)
auto-traffic-control release-timer (1062)
This command sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no
form to disable this trap.
S
YNTAX
[no] snmp-server enable port-traps atc multicast-alarm-clear
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-alarm-clear
Console(config-if)#
R C
ELATED OMMANDS
auto-traffic-control action (1063)
auto-traffic-control alarm-clear-threshold (1064)
– 1069 –
| Congestion Control Commands
C 31
HAPTER
Automatic Traffic Control Commands