Edge-Core ECS4110-28T Management Manual page 1237

This command configures the number of IGMP proxy group-specific or
ip igmp snooping
group-and-source-specific query messages that are sent out before the
vlan last-memb-
system assumes there are no more local members. Use the no form to
query-count
restore the default.
S
D
2
C
Global Configuration
C
This command will take effect only if IGMP snooping proxy reporting or
IGMP querier is enabled
E
This command configures the last-member-query interval. Use the no form
ip igmp snooping
to restore the default.
vlan last-memb-
query-intvl
S
D
10 (1 second)
C
Global Configuration
YNTAX
ip igmp snooping vlan vlan-id last-memb-query-count count
no ip igmp snooping vlan vlan-id last-memb-query-count
vlan-id - VLAN ID (Range: 1-4094)
count - The number of proxy group-specific or group-and-source-
specific query messages to issue before assuming that there are no
more group members. (Range: 1-255)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
XAMPLE
Console(config)#ip igmp snooping vlan 1 last-memb-query-count 7
Console(config)#
YNTAX
ip igmp snooping vlan vlan-id last-memb-query-intvl interval
no ip igmp snooping vlan vlan-id last-memb-query-intvl
vlan-id - VLAN ID (Range: 1-4094)
interval - The interval to wait for a response to a group-specific or
group-and-source-specific query message. (Range: 1-31744 tenths
of a second)
S
EFAULT ETTING
M
OMMAND ODE
– 1237 –
| Multicast Filtering Commands
C 40
HAPTER
(page 1228).
IGMP Snooping