Table 168: Static Multicast Interface Commands - Edge-Core ECS4110-28T Management Manual

S M
TATIC ULTICAST
ip igmp snooping
vlan mrouter
R
OUTING
This section describes commands used to configure static multicast routing on the
switch.

Table 168: Static Multicast Interface Commands

Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter
This command statically configures a (Layer 2) multicast router port on the
specified VLAN. Use the no form to remove the configuration.
S
YNTAX
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4094)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
D S
EFAULT ETTING
No static multicast router ports are configured.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
◆ Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router or switch connected over the
network to an interface (port or trunk) on this switch, that interface can
be manually configured to join all the current multicast groups.
IGMP Snooping must be enabled globally on the switch (using the
◆
igmp snooping command) before a multicast router port can take
effect.
– 1249 –
C 40
HAPTER
Function
Adds a multicast router port
Shows multicast router ports
| Multicast Filtering Commands
Static Multicast Routing
Mode
GC
PE
ip