Edge-Core ECS4110-28T Management Manual page 1284

| Multicast Filtering Commands
C 40
HAPTER
MVR for IPv4
mvr priority
mvr profile
E
XAMPLE
The following example enables MVR for domain 1:
Console(config)#mvr domain 1
Console(config)#
This command assigns a priority to all multicast traffic in the MVR VLAN.
Use the no form of this command to restore the default setting.
S
YNTAX
mvr priority priority
no mvr priority
priority - The CoS priority assigned to all multicast traffic forwarded
into the MVR VLAN. (Range: 0-7, where 7 is the highest priority)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command can be used to set a high priority for low-latency multicast
traffic such as a video-conference, or to set a low priority for normal
multicast traffic not sensitive to latency.
E
XAMPLE
Console(config)#mvr priority 6
Console(config)#
R C
ELATED OMMANDS
show mvr
This command maps a range of MVR group addresses to a profile. Use the
no form of this command to remove the profile.
S
YNTAX
mvr profile profile-name start-ip-address end-ip-address
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
start-ip-address - Starting IPv4 address for an MVR multicast
group. (Range: 224.0.1.0 - 239.255.255.255)
end-ip-address - Ending IPv4 address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
– 1284 –