Cluster Member; Rcommand - Edge-Core ECS4110-28T Management Manual

E
XAMPLE
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#
This command configures a Candidate switch as a cluster Member. Use the

cluster member

no form to remove a Member switch from the cluster.
S
YNTAX
D
EFAULT
No Members
C
OMMAND
Global Configuration
C
OMMAND
◆
◆
E
XAMPLE
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
This command provides access to a cluster Member CLI for configuration.

rcommand

S
YNTAX
C
OMMAND
Privileged Exec
C
OMMAND
◆
cluster member mac-address mac-address id member-id
no cluster member id member-id
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch.
(Range: 1-36)
S
ETTING
M
ODE
U
SAGE
The maximum number of cluster Members is 36.
The maximum number of cluster Candidates is 100.
rcommand id member-id
member-id - The ID number of the Member switch.
(Range: 1-36)
M
ODE
U
SAGE
This command only operates through a Telnet connection to the
Commander switch. Managing cluster Members using the local console
CLI on the Commander is not supported.
– 789 –
| System Management Commands
C 21
HAPTER
Switch Clustering