File Management; Table 57: Flash/File Commands - Edge-Core ECS4110-28T Management Manual

| System Management Commands
C 21
HAPTER

File Management

F M
ILE ANAGEMENT
To use jumbo frames, both the source and destination end nodes (such
◆
as a computer or server) must support this feature. Also, when the
connection is operating at full duplex, all switches in the network
between the two end nodes must be able to accept the extended frame
size. And for half-duplex connections, all devices in the collision domain
would need to support jumbo frames.
The current setting for jumbo frames can be displayed with the
◆
system command.
E
XAMPLE
Console(config)#jumbo frame
Console(config)#
Managing Firmware
Firmware can be uploaded and downloaded to or from an FTP/TFTP server.
By saving runtime code to a file on an FTP/TFTP server, that file can later
be downloaded to the switch to restore operation. The switch can also be
set to use new firmware without overwriting the previous version.
When downloading runtime code, the destination file name can be specified
to replace the current image, or the file can be first downloaded using a
different name from the current runtime code file, and then the new file set
as the startup file.
Saving or Restoring Configuration Settings
Configuration settings can be uploaded and downloaded to and from an
FTP/TFTP server. The configuration file can be later downloaded to restore
switch settings.
The configuration file can be downloaded under a new file name and then
set as the startup file, or the current startup configuration file can be
specified as the destination file to directly replace it. Note that the file
"Factory_Default_Config.cfg" can be copied to the FTP/TFTP server, but
cannot be used as the destination on the switch.

Table 57: Flash/File Commands

Command Function
General Commands
boot system Specifies the file or image used to start up the system
copy Copies a code image or a switch configuration to or
from flash memory or an FTP/TFTP server
delete Deletes a file or code image
dir Displays a list of files in flash memory
– 736 –
show
Mode
GC
PE
PE
PE