Configuring A Remote Loop Back Test - Edge-Core ECS4110-28T Management Manual

| Basic Administration Protocols
C 14
HAPTER
OAM Configuration
C
ONFIGURING A
R L
EMOTE OOP
B T
ACK EST
W I
EB NTERFACE
To display information about attached OAM-enabled devices:
Click Administration, OAM, Remote Interface.
1.
Figure 322: Displaying Status of Remote Interfaces
Use the Administration > OAM > Remote Loopback (Remote Loopback
Test) page to initiate a loop back test to the peer device attached to the
selected port.
CLI R
EFERENCES
"efm oam remote-loopback" on page 1395
◆
◆ "efm oam remote-loopback test" on page 1396
C U
OMMAND SAGE
• You can use this command to perform an OAM remote loop back test on
the specified port. The port that you specify to run this test must be
connected to a peer OAM device capable of entering into OAM remote
loop back mode.
During a remote loop back test, the remote OAM entity loops back
◆
every frame except for OAMPDUs and pause frames.
OAM remote loopback can be used for fault localization and link
◆
performance testing. Statistics from both the local and remote DTE can
be queried and compared at any time during loop back testing.
To perform a loopback test, first enable Remote Loop Back Mode, click
◆
Test, and then click End. The number of packets transmitted and
received will be displayed.
P
ARAMETERS
These parameters are displayed:
Loopback Mode of Remote Device
Port – Port identifier. (Range: 1-28/52)
◆
– 562 –