Edge-Core ECS4110-28T Management Manual page 1180

| VLAN Commands
C 37
HAPTER
Configuring Protocol-based VLANs
protocol-vlan
protocol-group
(Configuring Interfaces)
This command maps a protocol group to a VLAN for the current interface.
Use the no form to remove the protocol mapping for this interface.
S
YNTAX
protocol-vlan protocol-group group-id vlan vlan-id
[priority priority]
no protocol-vlan protocol-group group-id vlan
group-id - Group identifier of this protocol group.
(Range: 1-2147483647)
vlan-id - VLAN to which matching protocol traffic is forwarded.
(Range: 1-4094)
priority – The priority assigned to untagged ingress traffic.
(Range: 0-7, where 7 is the highest priority)
D S
EFAULT ETTING
No protocol groups are mapped for any interface.
Priority: 0
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
When creating a protocol-based VLAN, only assign interfaces via this
◆
command. If you assign interfaces using any of the other VLAN
commands (such as the
traffic of any protocol type into the associated VLAN.
When MAC-based, IP subnet-based, and protocol-based VLANs are
◆
supported concurrently, priority is applied in this sequence, and then
port-based VLANs last.
When a frame enters a port that has been assigned to a protocol VLAN,
◆
it is processed in the following manner:
If the frame is tagged, it will be processed according to the standard
■
rules applied to tagged frames.
If the frame is untagged and the protocol type matches, the frame
■
is forwarded to the appropriate VLAN.
If the frame is untagged but the protocol type does not match, the
■
frame is forwarded to the default VLAN for this interface.
– 1180 –
vlan command), these interfaces will admit