Displaying Mvr Receiver Groups - Edge-Core ECS4110-28T Management Manual

| Multicast Filtering
C 15
HAPTER
Multicast VLAN Registration for IPv4
D MVR
ISPLAYING
R G
ECEIVER ROUPS
Figure 363: Showing the Static MVR Groups Assigned to a Port
Use the Multicast > MVR (Show Member) page to show the multicast
groups either statically or dynamically assigned to the MVR receiver groups
on each interface.
CLI R
EFERENCES
"show mvr" on page 1293
◆
P
ARAMETERS
These parameters are displayed:
Domain ID – An independent multicast domain. (Range: 1-5)
◆
Group IP Address – Multicast groups assigned to the MVR VLAN.
◆
◆ VLAN – Indicates the MVR VLAN receiving the multicast service. Note
that this may be different from the MVR VLAN if the group address has
been statically assigned.
Port – Shows the interfaces with subscribers for multicast services
◆
provided through the MVR VLAN.
Up Time – Time this service has been forwarded to attached clients.
◆
Expire – Time before this entry expires if no membership report is
◆
received from currently active or new clients.
Count – The number of multicast services currently being forwarded
◆
from the MVR VLAN.
W I
EB NTERFACE
To display the interfaces assigned to the MVR receiver groups:
Click Multicast, MVR.
1.
Select Show Member from the Step list.
2.
Select an MVR domain.
3.
– 616 –