Pppoe Intermediate-Agent; Pppoe Intermediate-Agent Format-Type - Edge-Core ECS4110-28T Management Manual

pppoe
intermediate-agent
pppoe
intermediate-agent
format-type
This command enables the PPPoE Intermediate Agent globally on the
switch. Use the no form to disable this feature.
S
YNTAX
[no] pppoe intermediate-agent
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The switch inserts a tag identifying itself as a PPPoE Intermediate Agent
◆
residing between the attached client requesting network access and the
ports connected to broadband remote access servers (BRAS). The
switch extracts access-loop information from the client's PPPoE Active
Discovery Request, and forwards this information to all trusted ports
designated by the pppoe intermediate-agent trust
detects the presence of the subscriber's circuit-ID tag inserted by the
switch during the PPPoE discovery phase, and sends this tag as a NAS-
port-ID attribute in PPP authentication and AAA accounting requests to
a RADIUS server.
PPPoE IA must be enabled globally by this command before this feature
◆
can be enabled on an interface using the
port-enable command.
E
XAMPLE
Console(config)#pppoe intermediate-agent
Console(config)#
This command sets the access node identifier and generic error message
for the switch. Use the no form to restore the default settings.
S
YNTAX
pppoe intermediate-agent format-type {access-node-identifier
id-string | generic-error-message error-message}
no pppoe intermediate-agent format-type {access-node-
identifier | generic-error-message}
id-string - String identifying this switch as an PPPoE IA to the PPPoE
server. (Range: 1-48 ASCII characters)
error-message - An error message notifying the sender that the
PPPoE Discovery packet was too large.
– 881 –
| Authentication Commands
C 24
HAPTER
PPPoE Intermediate Agent
command. The BRAS

pppoe intermediate-agent