Displaying Continuity Check Errors - Edge-Core ECS4110-28T Management Manual

W
To show configuration settings for the fault notification generator:
1.
2.
3.
Figure 317: Showing Settings for the Fault Notification Generator
Use the Administration > CFM > Show Information (Show Continuity Check
D
ISPLAYING
Error) page to display the CFM continuity check errors logged on this
C C
ONTINUITY HECK
device.
E
RRORS
CLI R
◆
◆
P
ARAMETERS
These parameters are displayed:
◆
◆
◆
◆
◆
◆
16. This definition is based on the IEEE 802.1ag standard. Current software for this switch
I
EB NTERFACE
Click Administration, CFM.
Select Show Information from the Step list.
Select Show Fault Notification Generator from the Action list.
EFERENCES
"show ethernet cfm errors" on page 1372
"clear ethernet cfm errors" on page 1371
Level – Maintenance level associated with this entry.
Primary VLAN – VLAN in which this error occurred.
MEP ID – Identifier of remote MEP.
Interface – Port at which the error was recorded.
Remote MAC – MAC address of remote MEP.
Reason – Error types include:
LEAK – MA x is associated with a specific VID list
■
the VIDs in this MA can pass through the bridge port, no MEP is
configured facing outward (down) on any bridge port for this MA,
and some other MA y, at a higher maintenance level, and associated
with at least one of the VID(s) also in MA x, does have a MEP
configured on the bridge port.
only supports a single VLAN per MA. However, since it may interact with other devices
which support multiple VLAN assignments per MA, this error message may be reported.
– 555 –
| Basic Administration Protocols
C 14
HAPTER
Connectivity Fault Management
16 , one or more of