Assigning Static Mvr Multicast Groups To Interfaces - Edge-Core ECS4110-28T Management Manual

| Multicast Filtering
C 15
HAPTER
Multicast VLAN Registration for IPv4
A
SSIGNING
S MVR
TATIC
M G
ULTICAST ROUPS
I
TO NTERFACES
Figure 361: Configuring Interface Settings for MVR
Use the Multicast > MVR (Configure Static Group Member) page to
statically bind multicast groups to a port which will receive long-term
multicast streams associated with a stable set of hosts.
CLI R
EFERENCES
"mvr vlan group" on page 1292
◆
C U
OMMAND SAGE
Multicast groups can be statically assigned to a receiver port using this
◆
configuration page.
The IP address range from 224.0.0.0 to 239.255.255.255 is used for
◆
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
Only IGMP version 2 or 3 hosts can issue multicast join or leave
◆
messages. If MVR must be configured for an IGMP version 1 host, the
multicast groups must be statically assigned.
The MVR VLAN cannot be specified as the receiver VLAN for static
◆
bindings.
P
ARAMETERS
These parameters are displayed:
Domain ID – An independent multicast domain. (Range: 1-5)
◆
Interface – Port or trunk identifier.
◆
◆ VLAN – VLAN identifier. (Range: 1-4094)
Group IP Address – Defines a multicast service sent to the selected
◆
port. Multicast groups must be assigned from the MVR group range
configured on the Configure General page.
– 614 –