Pppoe Intermediate Agent; Table 89: Pppoe Intermediate Agent Commands - Edge-Core ECS4110-28T Management Manual

| Authentication Commands
C 24
HAPTER

PPPoE Intermediate Agent

PPP E I
O NTERMEDIATE
SNMP-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
TELNET-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
Console#
A
GENT
This section describes commands used to configure the PPPoE Intermediate
Agent (PPPoE IA) relay parameters required for passing authentication
messages between a client and broadband remote access servers.

Table 89: PPPoE Intermediate Agent Commands

Command Function
pppoe Enables the PPPoE IA globally on the switch
intermediate-agent
pppoe Sets the access node identifier and generic error
intermediate-agent message for the switch
format-type
pppoe Enables the PPPoE IA on an interface
intermediate-agent
port-enable
pppoe Sets the circuit-id or remote-id for an interface
intermediate-agent
port-format-type
pppoe Sets the trust mode for an interface
intermediate-agent trust
pppoe Enables the stripping of vendor tags from PPPoE
intermediate-agent Discovery packets sent from a PPPoE server
vendor-tag strip
clear pppoe Clears PPPoE IA statistics
intermediate-agent
statistics
show pppoe Displays PPPoE IA configuration settings
intermediate-agent info
show pppoe Displays PPPoE IA statistics
intermediate-agent
statistics
– 880 –
End IP address
192.168.1.19
192.168.1.30
End IP address
192.168.1.19
192.168.1.30
Mode
GC
GC
IC
IC
IC
IC
PE
PE
PE