Edge-Core ECS4110-28T Management Manual page 1161

This command configures the VLAN membership mode for a port. Use the
switchport mode
no form to restore the default.
S
YNTAX
D
EFAULT
All ports are in hybrid mode with the PVID set to VLAN 1.
C
OMMAND
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
Access mode is mutually exclusive with VLAN trunking (see the
trunking
interface cannot be set to access mode, and vice versa.
E
XAMPLE
The following shows how to set the configuration mode to port 1, and then
set the switchport mode to hybrid:
R
ELATED
switchport acceptable-frame-types (1158)
This command configures the PVID (i.e., default VLAN ID) for a port. Use
switchport native
the no form to restore the default.
vlan
S
YNTAX
switchport mode {access | hybrid | trunk}
no switchport mode
access - Specifies an access VLAN interface. The port transmits and
receives untagged frames on a single VLAN only.
hybrid - Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
trunk - Specifies a port as an end-point for a VLAN trunk. A trunk is
a direct link between two switches, so the port transmits tagged
frames that identify the source VLAN. Note that frames belonging to
the port's default VLAN (i.e., associated with the PVID) are also
transmitted as tagged frames.
S
ETTING
M
ODE
U
SAGE
command). If VLAN trunking is enabled on an interface, then that
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
C
OMMANDS
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4094)
– 1161 –
| VLAN Commands
C 37
HAPTER
Configuring VLAN Interfaces
vlan-