Edge-Core ECS4110-28T Management Manual page 1191

28/52-port gigabit ethernet layer 2+ switch
Hide thumbs Also See for ECS4110-28T:
Table of Contents

Advertisement

C
OMMAND
Interface Configuration
C
OMMAND
Specifies a CoS priority to apply to the port VoIP traffic on the Voice VLAN.
The priority of any received VoIP packet is overwritten with the new
priority when the Voice VLAN feature is active for the port.
E
XAMPLE
The following example sets the CoS priority to 5 on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan priority 5
Console(config-if)#
This command selects a method for detecting VoIP traffic on a port. Use
switchport voice
the no form to disable the detection method on the port.
vlan rule
S
YNTAX
D
EFAULT
OUI: Enabled
LLDP: Disabled
C
OMMAND
Interface Configuration
C
OMMAND
M
ODE
U
SAGE
[no] switchport voice vlan rule {oui | lldp}
oui - Traffic from VoIP devices is detected by the Organizationally
Unique Identifier (OUI) of the source MAC address.
lldp - Uses LLDP to discover VoIP devices attached to the port.
S
ETTING
M
ODE
U
SAGE
When OUI is selected, be sure to configure the MAC address ranges in
the Telephony OUI list (see the
address OUI numbers must be configured in the Telephony OUI list so
that the switch recognizes the traffic as being from a VoIP device.
LLDP checks that the "telephone bit" in the system capability TLV is
turned on. See
"LLDP Commands" on page 1323
on LLDP.
– 1191 –
| VLAN Commands
C
37
HAPTER
Configuring Voice VLANs
voice vlan mac-address
for more information
command. MAC

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecs4110-28pEcs4110-52tEcs4110-52p

Table of Contents