Edge-Core ECS4110-28T Management Manual page 1242

| Multicast Filtering Commands
C 40
HAPTER
IGMP Snooping
ip igmp snooping
vlan static
clear ip igmp
snooping groups
dynamic
This command adds a port to a multicast group. Use the no form to
remove the port.
S
YNTAX
[no] ip igmp snooping vlan vlan-id static ip-address interface
vlan-id - VLAN ID (Range: 1-4094)
ip-address - IP address for multicast group
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Static multicast entries are never aged out.
◆
When a multicast entry is assigned to an interface in a specific VLAN,
◆
the corresponding traffic can only be forwarded to ports within that
VLAN.
E
XAMPLE
The following shows how to statically configure a multicast group on a port.
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet 1/5
Console(config)#
This command clears multicast group information dynamically learned
through IGMP snooping.
S
YNTAX
clear ip igmp snooping groups dynamic
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
This command only clears entries learned though IGMP snooping. Statically
configured multicast address are not cleared.
– 1242 –