Edge-Core ECS4110-28T Management Manual page 1013

transceiver-
threshold tx-power
threshold-value – The threshold of the transceiver temperature.
(Range: -12800 - 12800 in units of 0.01 Celsius)
D S
EFAULT ETTING

High Alarm: 75.00 C

HIgh Warning: 70.00 C

Low Alarm: -123.00 C

Low Warning: 0.00 C
C M
OMMAND ODE
Interface Configuration (SFP Ports)
C U
OMMAND SAGE
Refer to the Command Usage section under the
◆
current command for more information on configuring transceiver
thresholds.
Trap messages enabled by the
◆
to any management station configured by the
command.
E
XAMPLE
The following example sets alarm thresholds for the transceiver
temperature at port 1.
Console(config)interface ethernet 1/52
Console(config-if)#transceiver-threshold temperature low-alarm 97
Console(config-if)#transceiver-threshold temperature high-alarm -83
Console#
This command sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or warning
message.
S
YNTAX
transceiver-threshold tx-power {high-alarm | high-warning |
low-alarm | low-warning} threshold-value
high-alarm – Sets the high power threshold for an alarm message.
high-warning – Sets the high power threshold for a warning
message.
low-alarm – Sets the low power threshold for an alarm message.
low-warning – Sets the low power threshold for a warning
message.
threshold-value – The power threshold of the transmitted signal.
(Range: -4000 - 820 in units of 0.01 dBm)
– 1013 –
| Interface Commands
C 27
HAPTER
Transceiver Threshold Configuration
transceiver-threshold
transceiver-monitor command are sent
snmp-server host