Edge-Core ECS4110-28T Management Manual page 761

This command adds a syslog server host IP address that will receive
logging host
logging messages. Use the no form to remove a syslog server host.
S
YNTAX
logging host host-ip-address [port udp-port]
no logging host host-ip-address
D
EFAULT
UPD Port: 514
C
OMMAND
Global Configuration
C
OMMAND
Use this command more than once to build up a list of host IP
◆
addresses.
◆ The maximum number of host IP addresses allowed is five.
E
XAMPLE
Console(config)#logging host 10.1.0.3
Console(config)#
This command controls logging of error messages, sending debug or error
logging on
messages to a logging process. The no form disables the logging process.
S
YNTAX
[no] logging on
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
The logging process controls error messages saved to switch memory or
sent to remote syslog servers. You can use the
control the type of error messages that are stored in memory. You can use
the logging trap
sent to specified syslog servers.
host-ip-address - The IPv4 or IPv6 address of a syslog server.
udp-port - The UDP port number used by the remote server.
(Range: 1-65535)
S
ETTING
M
ODE
U
SAGE
S
ETTING
M
ODE
U
SAGE
command to control the type of error messages that are
– 761 –
| System Management Commands
C 21
HAPTER
logging history
Event Logging
command to