Table 113: Interface Commands - Edge-Core ECS4110-28T Management Manual

27
I
NTERFACE
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN; or perform cable diagnostics
on the specified interface.

Table 113: Interface Commands

Command Function
Interface Configuration
interface Configures an interface type and enters interface
configuration mode
alias Configures an alias name for the interface
capabilities Advertises the capabilities of a given interface for use
in autonegotiation
description Adds a description to an interface configuration
discard Discards CDP or PVST packets
flowcontrol Enables flow control on a given interface
media-type Forces the transceiver mode to use for SFP ports
negotiation Enables autonegotiation of a given interface
shutdown Disables an interface
speed-duplex Configures the speed and duplex operation of a given
interface when autonegotiation is disabled
clear counters Clears statistics on an interface
show discard Displays if CDP and PVST packets are being discarded PE
show interfaces brief Displays a summary of key information, including
operational status, native VLAN ID, default priority,
speed/duplex mode, and port type
show interfaces counters Displays statistics for the specified interfaces
show interfaces status Displays status for the specified interface
show interfaces Displays the administrative and operational status of
switchport an interface
Transceiver Threshold Configuration
transceiver-monitor Sends a trap when any of the transceiver's operational
values fall outside specified thresholds
transceiver-threshold- Uses default threshold settings obtained from the
auto transceiver to determine when an alarm or trap
message should be sent
transceiver-threshold Sets thresholds for transceiver current which can be
current used to trigger an alarm or warning message
transceiver-threshold Sets thresholds for the transceiver power level of the
rx-power received signal which can be used to trigger an alarm
or warning message
– 995 –
C
OMMANDS
Mode
GC
IC
IC
IC
IC
IC
IC
IC
IC
IC
PE
PE
NE, PE
NE, PE
NE, PE
IC
IC
IC
IC