Edge-Core ECS4110-28T Management Manual page 1066

| Congestion Control Commands
C 31
HAPTER
Automatic Traffic Control Commands
auto-traffic-control
auto-control-release
C U
OMMAND SAGE
◆ Once the upper threshold is exceeded, a trap message may be sent if
configured by the snmp-server enable port-traps atc broadcast-alarm-
fire command or snmp-server enable port-traps atc multicast-alarm-
fire command.
◆ After the upper threshold is exceeded, the control timer must first
expire as configured by the
before a control response is triggered if configured by the
control action command.
E
XAMPLE
This example sets the trigger threshold for automatic storm control for
broadcast traffic on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast alarm-fire-threshold 255
Console(config-if)#
This command automatically releases a control response of rate-limiting
after the time specified in the
has expired.
S
YNTAX
auto-traffic-control {broadcast | multicast}
auto-control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
C M
OMMAND ODE
Interface Configuration (Ethernet)
C U
OMMAND SAGE
This command can be used to automatically stop a control response of
◆
rate-limiting after the specified action has been triggered and the
release timer has expired.
To release a control response which has shut down a port after the
◆
specified action has been triggered and the release timer has expired,
use the auto-traffic-control control-release
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast auto-control-release
Console(config-if)#
– 1066 –
auto-traffic-control apply-timer
auto-traffic-control release-timer
command.
command
auto-traffic-
command