Edge-Core ECS4110-28T Management Manual page 1067

auto-traffic-control
control-release
SNMP Trap Commands
snmp-server
enable port-traps
atc broadcast-
alarm-clear
This command manually releases a control response.
S
YNTAX
auto-traffic-control {broadcast | multicast} control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
C M
OMMAND ODE
Interface Configuration (Ethernet)
C U
OMMAND SAGE
This command can be used to manually stop a control response of rate-
limiting or port shutdown any time after the specified action has been
triggered.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast control-release
Console(config-if)#
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no
form to disable this trap.
S
YNTAX
[no] snmp-server enable port-traps atc broadcast-alarm-clear
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-clear
Console(config-if)#
R C
ELATED OMMANDS
auto-traffic-control action (1063)
auto-traffic-control alarm-clear-threshold (1064)
– 1067 –
| Congestion Control Commands
C 31
HAPTER
Automatic Traffic Control Commands