Table 65: Time Commands - Edge-Core ECS4110-28T Management Manual

show logging
sendmail
T
IME
C U
OMMAND SAGE
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
E
XAMPLE
Console(config)#logging sendmail source-email bill@this-company.com
Console(config)#
This command displays the settings for the SMTP event handler.
C M
OMMAND ODE
Normal Exec, Privileged Exec
E
XAMPLE
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.168.1.19
SMTP Minimum Severity Level: 7
SMTP destination email addresses
-----------------------------------------------
ted@this-company.com
SMTP Source Email Address: bill@this-company.com
SMTP Status: Enabled
Console#
The system clock can be dynamically set by polling a set of specified time
servers (NTP or SNTP). Maintaining an accurate time on the switch enables
the system log to record meaningful dates and times for event entries. If
the clock is not set, the switch will only record the time from the factory
default set at the last bootup.

Table 65: Time Commands

Command Function
SNTP Commands
sntp client Accepts time from specified time servers
sntp poll Sets the interval at which the client polls for time
sntp server Specifies one or more time servers
show sntp Shows current SNTP configuration settings
– 769 –
| System Management Commands
C 21
HAPTER
Time
Mode
GC
GC
GC
NE, PE