Edge-Core ECS4110-28T Management Manual page 1051

Use this command to specify the destination port to monitor the mirrored
rspan destination
traffic. Use the no form to disable RSPAN on the specified port.
S
D
Traffic exiting the destination port is untagged.
C
Global Configuration
C
◆
◆
◆
◆
◆
E
The following example configures port 4 to receive mirrored RSPAN traffic:
YNTAX
rspan session session-id destination interface interface [tagged |
untagged]
no rspan session session-id destination interface interface
session-id – A number identifying this RSPAN session. (Range: 1)
Only one mirror session is allowed, including both local and remote
mirroring. If local mirroring is enabled with the
command, then no session can be configured for RSPAN.
interface - ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
tagged - Traffic exiting the destination port carries the RSPAN VLAN
tag.
untagged - Traffic exiting the destination port is untagged.
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
Only one destination port can be configured on the same switch per
session, but a destination port can be configured on more than one
switch for the same session.
Only 802.1Q trunk or hybrid (i.e., general use) ports can be configured
as an RSPAN destination port – access ports are not allowed (see
switchport mode).
Only ports can be configured as an RSPAN destination – static and
dynamic trunks are not allowed.
The source port and destination port cannot be configured on the same
switch.
A destination port can still send and receive switched traffic, and
participate in any Layer 2 protocols to which it has been assigned.
XAMPLE
Console(config)#rspan session 1 destination interface ethernet 1/2
Console(config)#
– 1051 –
| Port Mirroring Commands
C 30
HAPTER
RSPAN Mirroring Commands
port monitor