Table 192: Show Ethernet Cfm Configuration Traps - Display Description - Edge-Core ECS4110-28T Management Manual

This example shows the configuration status for continuity check and
cross-check traps.
Console#show ethernet cfm configuration traps
CC MEP Up Trap
CC MEP Down Trap
CC Configure Trap
CC Loop Trap
Cross Check MEP Unknown Trap :Disabled
Cross Check MEP Missing Trap :Disabled
Cross Check MA Up
Console#

Table 192: show ethernet cfm configuration traps - display description

Field Description
CC MEP Up Trap Sends a trap if a remote MEP is discovered and added to the local
database, the port state of a previously discovered remote MEP
changes, or a CCM is received from a remote MEP which as an
expired entry in the archived database.
CC Mep Down Trap Sends a trap if this device loses connectivity with a remote MEP, or
connectivity has been restored to a remote MEP which has recovered
from an error condition.
CC Configure Trap Sends a trap if this device receives a CCM with the same MPID as its
own but with a different source MAC address, indicating that a CFM
configuration error exists.
CC Loop Trap Sends a trap if this device receives a CCM with the same source MAC
address and MPID as its own, indicating that a forwarding loop
exists.
Cross Check MEP A CCM is received from a MEP that has not been configured as a
Unknown Trap DSAP (see the
a remote MEP (see the
through previous CCM messages.
Cross Check MEP This device failed to receive three consecutive CCMs from another
Missing Trap MEP in the same MA.
Cross Check MA Up Generates a trap when all remote MEPs belonging to an MA come up.
This example shows the CFM status for port 1.
Console#show ethernet cfm configuration interface ethernet 1/1
Ethernet 1/1 CFM Status:Enabled
Console#
– 1361 –
C
HAPTER
:Disabled
:Disabled
:Disabled
:Disabled
:Disabled
ethernet cfm mep command), manually configured as
mep crosscheck mpid
| CFM Commands
42
Defining CFM Structures
command), nor learned