Show Snmp Notify-Filter; Additional Trap Commands; Memory - Edge-Core ECS4110-28T Management Manual

show snmp
notify-filter

Additional Trap Commands

memory

This command displays the configured notification logs.
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
This example displays the configured notification logs and associated
target hosts.
Console#show snmp notify-filter
Filter profile name
----------------------------
A1
Console#
This command sets an SNMP trap based on configured thresholds for
memory utilization. Use the no form to restore the default setting.
S
YNTAX
memory {rising rising-threshold | falling falling-threshold}
no memory {rising | falling}
rising-threshold - Rising threshold for memory utilization alarm
expressed in percentage. (Range: 1-100)
falling-threshold - Falling threshold for memory utilization alarm
expressed in percentage. (Range: 1-100)
D S
EFAULT ETTING
Rising Threshold: 90%
Falling Threshold: 70%
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Once the rising alarm threshold is exceeded, utilization must drop beneath
the falling threshold before the alarm is terminated, and then exceed the
rising threshold again before another alarm is triggered.
E
XAMPLE
Console(config)#memory rising 80
Console(config)#memory falling 60
Console#
R C
ELATED OMMANDS
show memory (728)
– 813 –
C
HAPTER
Additional Trap Commands
IP address
----------------
10.1.19.23
| SNMP Commands
22