Edge-Core ECS4110-28T Management Manual page 461

Figure 253: Showing the OID Subtree Configured for SNMP Views
Use the Administration > SNMP (Configure Group) page to add an SNMPv3
C
ONFIGURING
group which can be used to set the access policy for its assigned users,
SNMP 3 G
V ROUPS
restricting them to specific read, write, and notify views. You can use the
pre-defined default groups or create new groups to map a set of SNMP
users to SNMP views.
CLI R
◆
P
ARAMETERS
These parameters are displayed:
◆
◆
◆
◆
◆
◆
EFERENCES
"show snmp group" on page 808
Group Name – The name of the SNMP group to which the user is
assigned. (Range: 1-32 characters)
Security Model – The user security model; SNMP v1, v2c or v3.
Security Level – The following security levels are only used for the
groups assigned to the SNMP security model:
noAuthNoPriv – There is no authentication or encryption used in
■
SNMP communications. (This is the default security level.)
AuthNoPriv – SNMP communications use authentication, but the
■
data is not encrypted.
AuthPriv – SNMP communications use both authentication and
■
encryption.
Read View – The configured view for read access.
(Range: 1-32 characters)
Write View – The configured view for write access.
(Range: 1-32 characters)
Notify View – The configured view for notifications.
(Range: 1-32 characters)
– 461 –
| Basic Administration Protocols
C 14
HAPTER
Simple Network Management Protocol